Swimming Pools Traditional chlorine pools afford a lot of disadvantages such as uncomfortable side effects and maintenance difficulties hence why saltwater pools prove the ideal alternative. But how exactly do you convert your above-ground pool t o a saltwater model? Well, the guide below will show you how to convert your above ground pool to saltwater simply and affordably. Contents1 Picking out a chlorinator2 Draining your pool3 The installation phase4 Balancing water-to-salt ratio5 Monitoring Picking out a chlorinator The first step is identifying a saltwater system which is, quite frankly, the heart of such a pool. It keeps the pH levels in check, maintains hygiene and ensures that the salt-derived chlorine strikes the right balance between too little and too much. Two variations of saltwater systems exist for an above-ground pool namely an in-line generator and an over-hanging build. The latter is installed over the pool’s wall as its name suggests while the former takes residence close to the filter on the outside. The general rule of thumb to remember here is to get a chlorinator that can handle at least a third above your pool’s maximum capacity. This allowance eases the strain on the salt cell thereby increasing longevity. Draining your pool Might seem like a simple enough task however there a few considerations to take into account. For one, what is your city’s policy on draining vast amounts of water into the street or alleyways? Such information should be available at your local state department alongside pointers on proper pool water disposal techniques. Also, remember to only use pumps suited to above-ground pools for draining. The installation phase Once you acquire the saltwater system you picked out in step one, the first thing you ought to do is get your hands on the owner’s manual which contains specific guidelines on how to proceed with the installation. The first step is always to gradually fill the pool with fresh water. For some systems, it is advised to add salt as the pool is filling but for others, it is required to wait until the filling is complete before adding any salt. Which route you should take is usually highlighted in the said manual. Remember to use only pool salt and not mineral or sea salts which aren’t as pure and don’t dissolve as fast. Finally, you should only turn on the saltwater system once your pool is filled to capacity. You can use this waiting time to familiarize more with the owner’s manual. Balancing water-to-salt ratio The ideal water-to-salt ratio varies from pool to pool depending on a number of factors such as pool size and pool capacity just to name a few. Lucky for you, you need not trouble yourself with such concerns as this ratio is clearly stipulated in your owner’s manual. After steps 4 and 3 are over and done with, it is now time to turn on your saltwater system. Monitoring It’s often the norm that modern-day saltwater systems will do the monitoring for you but there are a couple of models that don’t. If that’s the case, then you’d need to install a separate monitoring system so that you can keep tabs on the salt levels. There you have it folks, the lowdown to converting your above-ground pool to saltwater. As you can see, it’s not that hard so it should be a walk in the park. Good luck!